Turn off Power and Sleep mode settings will ensure that your agent machine doesn't get locked or goes to sleep mode automatically. To make sure that agent machine is not locked due to power and sleep mode settings user must perform below two steps: If this helps, please mark this as “ Accepted Solution ” as it will help several others with the same issue to get it resolved without hassles.To simply say thanks, please click the " Thumbs Up " button to give me a Kudos to appreciate my efforts to help.By default windows Powers and Sleep settings are configured in way that screen get locked after specific interval of time. Let me know how that pans out, I hope you have a good day ahead, And Feel free to ask your queries as this forum has some of the best people in the world available and ready to help. Adjust the Windows display resolution to a setting that is compatible with the monitor. Wait 5 seconds and then turn on the computer by pressing the Power button again.ĥ. Press the Menu button on the front panel and select Factory Reset.Ĥ. If the monitor has a factory reset or restore options, set it. If the computer is on, wait until the hard drive activity light on the computer is not lit and then press and hold the Power button on the computer case until the computer turns off.ģ. The monitor is not receiving a video signal from the computer that it can detect and use. § The power light on the monitor comes on but the screen displays one of the messages again. For some computers, updating the BIOS can correct these types of suspending problems. Turn the monitor off when it is not being used or disable suspend mode on the computer. This indicates that the monitor was unable to detect that the computer had awakened from suspend mode. § The image from the computer displays on the monitor and you can use the computer again. Press the power button on the monitor to turn on the monitor.
The power light on the monitor should be off. Cycle the power on the monitor as follows:ġ.
Use the following steps to see if the monitor can display screens from safe mode:ġ. The display's resolution used by Windows has probably been set to a resolution that cannot be used by the monitor. Check with an alternate video cable (HDMI or VGA) If the issue persists, try the below steps: However, if the monitor displays any of these messages when the computer should be displaying video, something is wrong. The message - "No Input Signal" is normal when the computer truly goes into sleep mode or loses the video signal (such as when the computer is turned off). To HP Forums, this is a great place to get support, find answers and tips, Thank you for posting your query, I'll be more than glad to help you out As I understand the monitor isn't getting detected though the cables are connected properly.
0 kommentar(er)
